Accessories

Horn Kartesian for TWT30_vMS

Aluminium machined horn, dedicated to Twt30_vMS. This horn provide provides higher sensitivity to the Twt30_vMS in the mid mid-band. As a consequence, the Twt30_vMS can play higher sound level with very low THD, or reach soft crossover point around 1800Hz.

Tube for Kartesian kit

Vent with optimized cross section to avoid noises and turbulences in the air flow. It is quiet with air speed until 22m/s. Equivalent cylinder for enclosure calculation is : Ø45mm / Length : 80mm. Suitable for loudspeakers until ~135mm diameter. Hole diameter to be cut on the enclosure is Ø75mm, with recommended 3mm chamfer at 45°. Four blades ensure stable assembling.

Passive crossover Kartesian for KOMPACTE 4 kit, PCB board, external dimensions 148 x 83 mm

Wires to connect loudspeakers are included on crossover (Silver plated cooper, PTFE sheath).

Passive crossover Kartesian for KOURTISAN 4.2 kit, PCB board, MKP capacitor, external dimensions 148 x 83 mm

This crossover is dedicated to the Kourtisane 4.2 speaker kit. It works with Sub120_vHP (or Sub120_vHP-F) and Twt28_vHP.

Horn Kartesian for Twt28_vMS

Aluminium machined horn, dedicated to Twt30_vMS. This horn provides higher sensitivity to the Twt28_vMS from 1000Hz. As a consequence, the Twt28_vMS can play higher sound level with very low THD, or reach soft crossover point around 2500Hz.

Passive crossover for Kartesian COX120_VHP, PCB board, silver capacitor, external dimensions 143 x 83 mm

Diaphragm to repair Kartesian Cmp35_vPA, 8 ohm

Passive crossover Kartesian for KOURTISANE 4.8 kit, PCB board, silver capacitor, external dimensions 148 x 83 mm

Wires to connect loudspeakers are included on crossover board (Silver plated cooper, PTFE sheath).