Compression driver

Beyma
SMC60-8

€200.85 IT/piece
In stock

SMC60
8 ohm

Compression driver Beyma SMC-60, 8 ohm, 2-inch throat

1SMC608R

Eighteen Sound
ND1075-8

€176.64 IT/piece
In stock

ND1075
8 ohm

Compression driver 18 Sound ND1075, 8 ohm

The ND1075 is a 1 inch exit neodymium high frequency compression driver specifically designed for high quality applications. Equipped with proprietary phase plug architecture, the ND1075 has been developed to give high level manufacturing consistency and smooth coherent wavefront at horn entrance over all the working frequency range. This phase plug design, with its short openings and high flare rate value assures low distortion and remarkable improvements in mid-high frequency reproduction. With its ellipsoidal suspension shape, the titanium diaphragm assembly exhibits constant slope response from 1kHz to 18kHz with uniform smooth roll-off behavior. An edge-wound aluminum voice coil, wounded on proprietary treated Nomex, completes diaphragm assembly. Thanks to its physical properties, the proprietary treated Nomex former shows 30% higher value of tensile elongation at working operative temperature (200°C) when compared to Kapton. Moreover, this proprietary former material is suitable to work also in higher moisture contents environments. Through careful use of elementary pieces of neodymium magnets, Eighteen Sound engineers have developed a powerful neodymium magnet assembly able to reach 18 KGauss in the gap in compact and lightweight structure. A copper ring on the pole piece reduces inductance above 10 kHz improving phase and impedance linearization. The custom designed O-ring creates a tight seal between the plate and the cover assuring air chamber loading. Excellent heat dissipation and thermal exchange are guaranteed by the direct contact between the magnetic structure and the aluminum cover that allows to obtain a lower power compression value. The ability to perform properly under inclement weather conditions is a key-point of the Eighteen Sound philosophy. A special treatment is applied to the magnet and the top and back plates of the magnetic structure making the ND1075 driver more resistant to the corrosive effects of salts and oxidization than any other treatment used by any other manufacturer.

0421T8M420 8ohm