Search results for 'B C'

The PHL 6211Nd is a neodymium high SPL driver, 15" nominal diameter equipped with a natural convection air cooling system, it gives 98 dB/1w/1m sensivity and 1000 Watts AES power handling capacity, with usable frequency range from 30 to 1000 Hz. This model can be loaded in bass-reflex 75L set at 38 Hz.

The PHL 6311Nd is a high SPL neodymium driver, 15" nominal diameter equipped with a forced air cooling system, it gives 98 dB/1w/1m sensivity and 1200 Watts AES power handling capacity, with usable frequency range from 30 to 1000 Hz. This model can be loaded in bass-reflex 65L set at 42 Hz.

High efficiency extended driver 6.5", impedance 16 ohm, direct radiation driver crossoverable, from 400 Hz (single) or 300 Hz (dual). These drivers are the Studio Monitoring versions of models SP1060/1070. All the PHL AUDIO recipes for exceptional sound transcription have been integrated, resulting in full expressiveness in the so sensitive midrange band, against the sole counterpart of 1dB loss of sensitivity. Their prefered frequency band extends from 400Hz to 4000 Hz (single unit) while the close coupling of a pair authorizes X-overing from 300Hz. The optimum acoustical load is situated under 3L volume, sealed or tuned around Fs.

Extended driver, impedance 16 ohm, 6.5", very high Quality Sounding bass-midrange, sound quality optimized over bass extension.

Dedicated to proximity sound reinforcement systems these models are optimum for two way Bass-Reflex systems using one or two drivers per system, with a X-over frequency situated around 3kHz to 5kHz. Their particular design prevents over-excursion damage making them extremely rugged without any counterpart in the sound which remains accurate and dynamic. Recommended Reflex enclosure is 10L to 12L tuned from 60Hz to 65Hz.

Architecture highlights : - High excursion S roll rubber surround - High definition ultra light CCAR Voice coil - Natural convection Intercooler System - Both side coated curvilinear cone These 6.5"ultimate sounding quality Bass-Midrange drivers have been designed to match advanced studio monitoring requirements for proximity monitoring. The exceptional sound accuracy of these units results from a careful design using A/B listening tests to select technological solutions, which authorizes their use up to 2.5kHz without any compromise, and up to 4.0kHz with full preservation of dynamic behavior (Compromise is on directivity pattern only). Optimum Bass-Reflex loading is situated between 12L and 16L tuned from 45Hz to 40Hz.

The main purpose of these models is sound reinforcement direct radiation multi-way systems when the low freq. extension required does not allow types SP1040/1050 to operate in good conditions. Designed with higher Xmax capability types SP1060/1070 can be X-overed from as low as 400 Hz when single or 300 Hz when used in pairs, and will then exhibit all their sound quality potential.