Speaker 18 Sound 15NMB420, 4 ohm, 15 inch

Brand 
Eighteen Sound
Model 
15NMB420
SKU 
15NMB420-4
Manufacturer code 
022154N250
Product type 
Cone driver
Brand
Eighteen Sound
Model
15NMB420
TLHP code
15NMB420-4
Manufacturer code
022154N250
Product type 
Cone driver

Unavailable

  • The 15NMB420 is a 380 mm (15 in) neodymium mid-bass transducer designed for professional monitoring and sound reinforcement. The most extended bass, lowest distortion and best control is usually realized in properly designed vented enclosures. Typical enclosure sizes range from 80lit. up with tunings from 40 to 50Hz.

    Low-frequency equalization is suggested in order to improve the bass output. A conservative idea of amplifier size ranges from 400-800W, allowing maximum output with no risk of speaker damage when properly used. The neodymium magnet assembly assures high flux concentration, low power compression and excellent heat exchange, since the external magnet configuration is considerably more efficient than the traditional under-pole magnet topology. This allows to obtain high levels of force factor and power handling with a power to weight ratio at the upper level of the category.
    SDR (Single Demodulating Ring) technology has been used to reproduce instantaneous peaks on mid frequencies, reducing intermodulation distortion.
    The high quality paper cone has a smooth, curvilinear profile design that eliminates bell-mode resonances within the intended frequency range. This is carried by a specially treated and damped multiple roll linen suspension designed to control excursion maintaining the piston action linearity.
    The 15NMB420 employs a 75mm aluminum Interleaved Sandwich Voice coil (ISV), in which a high strength fiberglass former carries windings on both the outer and inner surfaces to achieve a mass balanced coil, resulting in an extremely linear motor assembly.
    A proprietary humidity-block cone treatment has been implemented in order to perform in outdoor environments under adverse weather conditions. In addition, special treatment of both the face and back plates results in a product which is far more resistant to the corrosive effects of salts and oxidization than any other treatment in use.

    99 dB SPL 1W / 1m average sensitivity
    75 mm (3 in) Interleaved Sandwich Voice coil (ISV)
    450 W AES power handling
    External neodymium magnet assembly
    Single Demodulating Rings (SDR) for lower distortion
    Weather protected cone and plates for outdoor usage
    Specially designed for compact two way systems

General

Product type Cone driver
Brand Eighteen Sound
Reference 15NMB420
Product code 022154N250

Informations

Nominal impedance 4 ohm

Datas

Weight ~4.8 kg


Question about Eighteen Sound 15NMB420-4

Ask a new question!

This system is only available for technical questions. For questions of prices, availability of products and deadline thank you to send your request by the contact page.


Informations Eighteen Sound 15NMB420-4

The 15NMB420 is a 380 mm (15 in) neodymium mid-bass transducer designed for professional monitoring and sound reinforcement. The most extended bass, lowest distortion and best control is usually realized in properly designed vented enclosures. Typical enclosure sizes range from 80lit. up with tunings from 40 to 50Hz.

Low-frequency equalization is suggested in order to improve the bass output. A conservative idea of amplifier size ranges from 400-800W, allowing maximum output with no risk of speaker damage when properly used. The neodymium magnet assembly assures high flux concentration, low power compression and excellent heat exchange, since the external magnet configuration is considerably more efficient than the traditional under-pole magnet topology. This allows to obtain high levels of force factor and power handling with a power to weight ratio at the upper level of the category.
SDR (Single Demodulating Ring) technology has been used to reproduce instantaneous peaks on mid frequencies, reducing intermodulation distortion.
The high quality paper cone has a smooth, curvilinear profile design that eliminates bell-mode resonances within the intended frequency range. This is carried by a specially treated and damped multiple roll linen suspension designed to control excursion maintaining the piston action linearity.
The 15NMB420 employs a 75mm aluminum Interleaved Sandwich Voice coil (ISV), in which a high strength fiberglass former carries windings on both the outer and inner surfaces to achieve a mass balanced coil, resulting in an extremely linear motor assembly.
A proprietary humidity-block cone treatment has been implemented in order to perform in outdoor environments under adverse weather conditions. In addition, special treatment of both the face and back plates results in a product which is far more resistant to the corrosive effects of salts and oxidization than any other treatment in use.

99 dB SPL 1W / 1m average sensitivity
75 mm (3 in) Interleaved Sandwich Voice coil (ISV)
450 W AES power handling
External neodymium magnet assembly
Single Demodulating Rings (SDR) for lower distortion
Weather protected cone and plates for outdoor usage
Specially designed for compact two way systems

All or a part of the characteristics displayed on this page are provided by the manufacturer, it is possible that some pieces of information are unavailable or wrong. In addition, the manufacturer may need to change the product specifications without notice at any time in order to improve the product, or to adapt his offer to the manufacturing and supply constraints.. We suggest you to contact us if you need further information, if you observe a mistake or if you wish to have confirmation about information.

Dimensions

Image Drawing & Mounting (1/2) cone driver Eighteen Sound Speaker 18 Sound 15NMB420, 4 ohm, 15 inch
Image Drawing & Mounting (2/2) cone driver Eighteen Sound Speaker 18 Sound 15NMB420, 4 ohm, 15 inch
This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x
This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x