Search results for 'horn'

The 745PB is no longer manufactured and replaced by the 745DPB which is the same driver but with two bolt circle patterns - a standard 4" and a second one of 3.5" shifted by 45º, for attachment to horns.

The 745PB is no longer manufactured and replaced by the 745DPB which is the same driver but with two bolt circle patterns - a standard 4" and a second one of 3.5" shifted by 45º, for attachment to horns.

Coaxial transducer designed for compact cabinets, with a low resonant frequency (65 Hz) and a dDemodulating ring in LF unit.

15 inch coaxial speaker with 8 ohm impedance on LF section and 16 ohm impedance on HF section, can be filtered with the crossover FD2XA from Beyma.

40 W continuous program power capacity 1" horn throat diameter 25 mm (1 in) aluminium voice coil Mylar diaphragm 1500 - 18000 Hz response 107 dB sensitivity

ES cone and center cap are adapted. This new diaphragm material has the fine, supple and high density fiber, and its characteristics successfully improve the mid-high frequency reproduction. ø146mm strong ferrite magnet is employed. Well tuned Qts / Mms values for ease of use in the back loaded horn enclosure.

ES cone and center cap are adapted. This new diaphragm material has the fine, supple and high density fiber, and its characteristics successfully improve the mid-high frequency reproduction. ø100mm strong ferrite magnet is employed. Well tuned Qts / Mms values for ease of use in the back loaded horn enclosure.

These models are an excellent alternative to types SP1040/1050 when very high SPL are needed in sound reinforcement. Sound transcription is of utmost accuracy due to the mastery of the diaphragm behavior even at full level, which allows for their use in studio monitoring too. Direct radiation within frequency band 400Hz - 4000 Hz, in a sealed volume not exceeding 3L is possible while use with a horn loaded for high power systems is its real destination.